2018-2019 Silverado or Sierra 2500 3500 Front Driver Seat Belt Retractor Cocoa Color

Fits The Driver Seat on Double and Crew Cab 2500 and 3500 Trucks only. 

Installation Instructions:

Replacing the Front Driver Seat Belt Retractor on a 2018-2019 Silverado or Sierra 2500/3500 is a relatively simple process that can be completed with the right tools and knowledge. Here are the steps you need to follow to replace the existing retractor with the new Cocoa Color Genuine part:

Tools needed:

• Socket wrench
• Torx bit set
• Flathead screwdriver

Skill Level:

• Intermediate

Time Needed:

• Approximately 30-60 minutes

Step 1: Remove the Old Retractor

• Move the driver's seat all the way forward to access the rear of the retractor.
• Remove the bolt holding the retractor in place using the socket wrench.
• Gently pry off the plastic cover that is located over the retractor using the flathead screwdriver.
• Using the Torx bit set, remove the screws holding the old retractor in place.
• Carefully pull the old retractor away from the vehicle.

Step 2: Install the New Retractor

• Connect the wiring harness to the new retractor.
• Position the new retractor in place where the old one was located.
• Replace the screws using the Torx bit set and tighten them.
• Snap the plastic cover back into place over the retractor.

Step 3: Test the New Retractor

• Test the new retractor by pulling the seat belt all the way out and releasing it to ensure it retracts smoothly.

Step 4: Final Check

• Once you have installed the new retractor and tested it, give it a final check to make sure it is secure and functioning correctly.

That's it! With these simple steps, you should be able to replace the old Front Driver Seat Belt Retractor on your 2018-2019 Silverado or Sierra 2500/3500 with the new Cocoa Color Genuine part. Remember to take your time and be patient during the process. If you encounter any problems or have any questions, consult a professional mechanic for assistance.