Ford Escape Focus Transit Connect (1) Rear Bumper Parking Aid Sensor Unpainted -

The Ford Escape, Focus and Transit Connect Rear Bumper Parking Aid Sensor is a genuine OEM (original equipment manufacturer) auto part that is designed to assist with parking and reversing maneuvers. This high-quality sensor is manufactured to meet or exceed the standards set by Ford, ensuring a perfect fit and optimal performance. It comes unpainted, allowing for a better match with the color of the car.

To install the Ford Escape Focus Transit Connect (1) Rear Bumper Parking Aid Sensor Unpainted - Genuine New with your own screws, follow the steps below:

1. Park your vehicle on a flat surface and turn off the engine.

2. Locate the area on the rear bumper where the new parking aid sensor will be installed.

3. Carefully remove any existing sensors or covers from the bumper, if necessary.

4. Align the new parking aid sensor with the mounting holes on the bumper.

5. Insert a screw through each mounting hole and tighten them using a socket set or wrench. Be careful not to over-tighten the screws as this could damage the sensor.

6. Repeat these steps for any additional sensors that need to be installed.

7. Paint the sensor to match the color of your vehicle, if desired.

8. Test the new sensor by putting the vehicle in reverse and verifying that it beeps when an object is detected.

The skill level required for this installation is low to moderate, and it should take approximately 30-60 minutes to complete. You will need a socket set or wrench to install the sensor with your own screws. No special tools are required for this installation.

Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle. Also, make sure the new sensor is securely mounted and properly aligned with the bumper for accurate detection.

VEHICLE FITMENT