Nissan Altima Maxima Quest 3.5L V6 Oil Cooler Hose OEM

Here are the steps to install a Nissan Altima Maxima Quest 3.5L V6 Oil Cooler Hose:

Tools needed:

• Drain pan
• Pliers
• Wrench set
• Oil filter wrench
• Torque wrench

Skill level: Intermediate

Time needed: 1-2 hours

Steps:

1. Locate the old oil cooler hose and determine which one needs to be replaced.

2. Place a drain pan under the oil cooler hose to catch any oil that may leak during the replacement process.

3. Use pliers to loosen the hose clamp on the end of the oil cooler hose that attaches to the engine block.

4. Use a wrench to loosen the other end of the oil cooler hose that attaches to the oil cooler.

5. Gently remove the old oil cooler hose from both the engine block and oil cooler.

6. Apply a small amount of oil to the new oil cooler hose fittings.

7. Attach the new oil cooler hose to the engine block and oil cooler by tightening the fittings with a wrench.

8. Tighten the hose clamp on the end of the oil cooler hose that attaches to the engine block with pliers.

9. Use an oil filter wrench to remove the oil filter.

10. Allow the oil to drain out of the oil filter housing.

11. Replace the O-ring on the oil filter housing.

12. Install a new oil filter.

13. Fill the engine with the recommended amount of oil.

14. Start the engine and check for any leaks.

15. Turn off the engine and check the oil level.

16. Use a torque wrench to tighten the fittings on the oil cooler hose to the manufacturer's specifications.

17. Dispose of the old oil filter and oil in an environmentally responsible manner.

18. That's it! The installation of the Nissan Altima Maxima Quest 3.5L V6 Oil Cooler Hose is now complete.