2020-2021 Ford Escape Passenger Side Fog Light Bezel Trim

If you're looking for a new passenger side fog light bezel trim for your 2020-2021 Ford Escape, look no further than this genuine OEM (original equipment manufacturer) auto part.

To install the 2020-2021 Ford Escape Passenger Side Fog Light Bezel Trim Genuine New, follow the steps below:

1. Park your vehicle on a flat surface and turn off the engine.

2. Locate the passenger side fog light that needs the new bezel trim installed.

3. Carefully remove any covers or shrouds that may be obstructing access to the fog light assembly.

4. Locate the bolts or screws that are holding the old bezel trim in place and remove them using a socket set or a wrench.

5. Carefully remove the old bezel trim from the fog light assembly.

6. Position the new bezel trim in the same location as the old one.

7. Secure the new bezel trim in place using the bolts or screws that you removed earlier.

8. Reinstall any covers or shrouds that you removed earlier.

The skill level required for this installation is low, and it should take approximately 15-30 minutes to complete. You will need a socket set or a wrench to remove the bolts or screws that are holding the old bezel trim in place. No special tools are required for this installation.

Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle.