2014-2020 Acura MDX Rear Door Handle To Latch Lock Control Cable. Fits Back doors Only.

Are you in need of a new rear door handle to latch lock control cable for your 2014-2020 Acura MDX? Look no further! Our Genuine OEM auto part is the perfect solution for your vehicle.

The door handle to latch lock control cable is a crucial component of your Acura MDX's door locking system. It connects the rear door handle to the latch mechanism, allowing you to open and close the door. A damaged or worn cable can cause the door to not open or close properly, making it difficult to get in and out of your vehicle.

To install a new rear door handle to latch lock control cable on a 2014-2020 Acura MDX, you can follow these steps:

1. First, open the rear door on the side where you will be replacing the cable.

2. Use a trim removal tool to carefully pry off the door panel on the inside of the door. Start at the bottom of the panel and work your way up, releasing the clips that hold the panel in place.

3. Once the panel is removed, you should be able to see the rear door handle and latch mechanism. Locate the end of the cable where it connects to the handle.

4. Use pliers to carefully disconnect the old cable from the handle. You may need to wiggle it back and forth a bit to release it.

5. Follow the cable to the latch mechanism and disconnect it from there as well.

6. Take the new cable and thread it along the interior of the door, following the path of the old cable.

7. Connect the new cable to the rear door handle and the latch mechanism, making sure the connections are secure.

8. Replace the door panel by aligning it with the clips and pressing it firmly into place.

9. Test the new cable by pulling on the rear door handle and making sure the latch mechanism unlocks and opens the door properly.

That's it! Your new rear door handle to latch lock control cable should now be installed and working properly on your Acura MDX.

VEHICLE FITMENT