Gas Cap for 4Runner, Camry, Sienna, Corolla, and Rav4 See Fitment Chart

The Genuine Toyota Gas Cap is the perfect solution for anyone looking to ensure their vehicle is running at its best. This high-quality, OEM (original equipment manufacturer) part is specifically designed for use in 4Runner, Camry, Sienna, Corolla, and Rav4 models. This means that you can trust that it will fit and function perfectly with your vehicle, unlike aftermarket or generic parts which may not offer the same level of compatibility or quality.

Installation Instructions:

1. Before starting, ensure that the engine is turned off and the key is removed from the ignition.

2. Locate the fuel filler cap on your Toyota 4Runner, Camry, Sienna, Corolla, or Rav4. It is typically located on the rear quarter panel or on the side of the vehicle.

3. Unscrew the old gas cap by turning it counterclockwise. If it is stuck or difficult to remove, try pressing down on it while turning or use a pair of pliers to grip and twist it off.

4. Inspect the fuel filler neck for any signs of damage or debris. If necessary, clean it with a rag or brush.

5. Take the new genuine Toyota gas cap and insert it into the fuel filler neck. Ensure that it is aligned properly and pushed in all the way.

6. Twist the new gas cap clockwise until you feel it click into place. This ensures a secure and tight seal.

7. Start the engine and check to make sure that the check engine light is off. A loose or faulty gas cap can trigger this warning light.

Tools Needed: None.

Skill Level: Beginner.

Time Required: Less than 1 minute.

VEHICLE FITMENT