2006-2014 Ford Mustang Convertible Upper Center Weatherstrip Seal

The 2006-2014 Ford Mustang Convertible Upper Center Weatherstrip Seal is a genuine OEM (original equipment manufacturer) auto part that is designed to enhance the weather resistance of your vehicle. This high-quality weatherstrip seal is manufactured to meet or exceed the standards set by Ford, ensuring a perfect fit and optimal performance.

To install the 2006-2014 Ford Mustang Convertible Upper Center Weatherstrip Seal Genuine New, follow the steps below:

1. Park your vehicle on a flat surface and turn off the engine.

2. Locate the old upper center weatherstrip seal that needs to be replaced. It is typically located on the top center edge of the convertible roof.

3. Carefully remove the old weatherstrip seal by pulling it away from the roof.

4. Clean the area where the new weatherstrip seal will be installed with soap and water to remove any dirt, debris, or wax residue.

5. Align the new weatherstrip seal with the edge of the convertible roof.

6. Carefully press the new weatherstrip seal onto the roof until it is fully seated.

7. Test the new weatherstrip seal by opening and closing the convertible roof to verify that it operates smoothly and that the seal is properly seated.

8. Repeat these steps for any additional weatherstrip seals that need to be replaced.

The skill level required for this installation is low, and it should take approximately 30-60 minutes to complete. No special tools are required for this installation.

Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle. Also, make sure the new weatherstrip seal is fully seated onto the roof for proper sealing.