The 2006-2009 Ford Fusion ABS Brake Control Module is an essential piece of equipment for any Ford Fusion owner. This Genuine OEM auto part is specifically designed for the Ford Fusion model years 2006-2009, and is for front wheel drive only.
To install the 2006-2009 Ford Fusion ABS Brake Control Module For Front Wheel Drive Only, follow the steps below:
Park your vehicle on a flat surface and turn off the engine.
Locate the old ABS brake control module that needs to be replaced.
Remove the fuse for the ABS brake control module from the fuse box to prevent electrical shock.
Locate the bolts or screws that are holding the old ABS brake control module in place and remove them using a socket set or a wrench.
Carefully remove the old ABS brake control module from the vehicle.
Position the new ABS brake control module in the same location as the old one.
Secure the new ABS brake control module in place using the bolts or screws that you removed earlier.
Reinstall the fuse for the ABS brake control module.
Turn on the engine and test the new ABS brake control module by driving the vehicle and checking for proper brake operation.
The skill level required for this installation is moderate, and it should take approximately 1-2 hours to complete. You will need a socket set or a wrench to remove the bolts or screws that are holding the old ABS brake control module in place. No special tools are required for this installation.
Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle.
