2005-2009 Ford F-150 Passenger Side Rear Bumper Top Step Pad

Passenger Side

This is a new rear bumper step pad for the 2005-2009 Ford F-150. It is a Genuine OEM (Original Equipment Manufacturer) part, meaning it is manufactured by Ford specifically for these vehicle models.

The rear bumper step pad is an important component of the vehicle's exterior, as it provides a non-slip surface for passengers to step on when entering or exiting the truck bed. Over time, the step pad can become worn or damaged, causing it to become slippery and potentially dangerous.

Installation Instructions:

Installing a new genuine Ford rear bumper step pad on a 2005-2009 Ford F-150 can be done with just a few basic tools. Here are the steps to follow:

Tools Needed:

• Socket wrench set
• Flat-head screwdriver
• Torx driver set

Skill Level:

• Moderate

Estimated Time:

• 30-60 minutes

1. Start by removing the old step pad from the rear bumper. This may involve removing screws or bolts that hold it in place. Use a socket wrench set to loosen and remove these fasteners.

2. Once the old step pad is removed, clean the surface of the bumper where the new step pad will be installed. Use a flat-head screwdriver to remove any old adhesive or debris.

3. Take the new genuine Ford rear bumper step pad and place it onto the bumper, making sure it is properly aligned. Use a Torx driver set to tighten the screws or bolts that secure it to the bumper.

4. Once the new step pad is securely attached, check it for proper fit and alignment. Make any necessary adjustments.

5. Finally, step back and admire your new genuine Ford rear bumper step pad!

Note: It is recommended to consult your vehicle's owner's manual for specific instructions and safety precautions before attempting this installation.