2004-2011 Ford Ranger 5 Speed Manual Transmission Gear Shift Boot

The 2004-2011 Ford Ranger 5 Speed Manual Transmission Gear Shift Boot is a new genuine Ford part that is designed to provide the perfect fit for your Ford Ranger. This part is an essential component of the manual transmission and is responsible for protecting the gear shift lever from dust and debris.

Please note that this does not fit any ranger older than 2004.

Installation Instructions:

To install the 2004-2011 Ford Ranger 5 Speed Manual Transmission Gear Shift Boot Genuine New, you will need the following tools:

• Flathead screwdriver
• Socket wrench set (depending on your vehicle)
• Trim removal tool (optional)

The skill level needed for this installation is considered to be easy to moderate. It should take approximately 30-45 minutes to complete.

Here are the steps to install the gear shift boot:

1. Begin by removing the shift knob from the gear shift lever. This is typically done by unscrewing it counterclockwise.

2. Use the flathead screwdriver or trim removal tool to gently pry up the edges of the old gear shift boot. Be careful not to damage the surrounding area.

3. Remove the old gear shift boot from the shift lever.

4. Use the socket wrench set to remove the bolts that secure the gear shift boot to the transmission tunnel. This step may vary depending on your vehicle.

5. Clean the area where the gear shift boot will be installed.

6. Install the new gear shift boot onto the shift lever.

7. Reinstall the bolts that secure the gear shift boot to the transmission tunnel. Tighten the bolts to the manufacturer's specifications.

8. Test the gear shift boot to ensure that it is securely installed.

9. Reinstall the shift knob onto the gear shift lever.

That's it! You have successfully installed the 2004-2011 Ford Ranger 5 Speed Manual Transmission Gear Shift Boot Genuine New.