2010-2021 Toyota 4Runner Rear ABS Sensor Wiring Harness

2010-2021 Toyota 4Runner rear ABS Sensor Wiring Harness

This is the wiring only as shown, ABS Sensor Not included. 

Our Genuine Part is brand new and has all the latest updates. The part is designed to never fail again. Of course, nothing is perfect, so we back it up with our industry-leading warranty in case something does go wrong. This part is made by the same company that made your vehicle, so you know it will be a 100% perfect fit every time, and the quality will be spot on.

Installation Instructions:

1. Before starting, ensure that the vehicle is parked on a flat and stable surface, and all occupants have vacated the area.

2. Locate the rear ABS sensor on your 2010-2021 Toyota 4Runner. It is typically located near the wheel hub assembly.

3. Follow the wiring harness from the ABS sensor to the nearest connector. This is where the new genuine Toyota rear ABS sensor wiring harness will be installed.

4. Using a pair of pliers or your fingers, gently unplug the old wiring harness from the connector. Take note of its orientation and location for future reference.

5. Take the new genuine Toyota rear ABS sensor wiring harness and plug it into the same connector as the old one. Ensure that it is aligned properly and pushed in all the way.

6. Follow the wiring harness back to the ABS sensor and secure it in place with zip ties or clips as necessary. Make sure that the harness is not twisted or kinked.

7. Test the ABS sensor to make sure it functions correctly. Drive the vehicle and perform a series of hard stops to ensure that the ABS system is working properly.

8. Once you are satisfied with the installation, replace any trim pieces that were removed and clean up any debris.

Tools Needed: Pliers, zip ties or clips.

Skill Level: Intermediate.

Time Required: 30-45 minutes.