Click to zoom in
The 2006-2014 Ford Mustang Convertible Upper Center Weatherstrip Seal is a genuine OEM (original equipment manufacturer) auto part that is designed to enhance the weather resistance of your vehicle. This high-quality weatherstrip seal is manufactured to meet or exceed the standards set by Ford, ensuring a perfect fit and optimal performance.
To install the 2006-2014 Ford Mustang Convertible Upper Center Weatherstrip Seal Genuine New, follow the steps below:
-
Park your vehicle on a flat surface and turn off the engine.
-
Locate the old upper center weatherstrip seal that needs to be replaced. It is typically located on the top center edge of the convertible roof.
-
Carefully remove the old weatherstrip seal by pulling it away from the roof.
-
Clean the area where the new weatherstrip seal will be installed with soap and water to remove any dirt, debris, or wax residue.
-
Align the new weatherstrip seal with the edge of the convertible roof.
-
Carefully press the new weatherstrip seal onto the roof until it is fully seated.
-
Test the new weatherstrip seal by opening and closing the convertible roof to verify that it operates smoothly and that the seal is properly seated.
-
Repeat these steps for any additional weatherstrip seals that need to be replaced.
The skill level required for this installation is low, and it should take approximately 30-60 minutes to complete. No special tools are required for this installation.
Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle. Also, make sure the new weatherstrip seal is fully seated onto the roof for proper sealing.
Read More
EASY NO HASSLE RETURN INFORMATION
Simply return your part in the exact same condition and packaging that you received it in within 30 days for a full refund of the purchase price of the part, minus the original shipping charges. You don't even have to contact us. Just be sure the read the requirements below and follow the instructions at the bottom of this page.
WHAT CAN NOT BE RETURNED:
Any part that does not have all of the original packaging with the attached manufacturer part number label.
Believe it or not, this is super important! Don't throw away the packaging. Manufacturers won't accept returns on a part without the genuine OEM Packaging, so we won't be able to credit you. (Even if the part is brand new with no packaging, we would have to return it to you).
WE ALSO CANNOT ACCEPT YOUR RETURN IF:
You have installed or attempted to install or disassemble the part
You have painted the part.
You have broken the part.
You have lost the original packaging.
You have gotten the part wet, or the part has greasy fingerprints.
ELECTRICAL PARTS.
Electrical parts can only be returned if they have not been installed, programmed, or plugged in. If the part shows signs, of an attempted install we will be unable to accept your return.
An electrical part is any part that plugs in, contains a switch, sensor, circuit board, or electrical wiring.
All Products are. covered by a 1-year Warranty.
Our Warranty Coverage
We will replace the parts free of charge for any reason not caused by collision or installation, other human intervention, incorrect application, modifications, use of the products outside the context of its normal, customary, and intended operating conditions (including without limitation, any form of commercial, fleet, rental or off-road use), or physical damage for 1 year and only for the vehicle in which the part was originally installed.
One Time replacement.
Warranty Covers only one replacement in the warranty period. Multiple Replacements are not covered, after one replacement warranty will no longer be in effect.
Warranty Is nontransferable and is only valid for the VIN number of the vehicle for which it was purchased. Warranty does not transfer to the new owner of the item purchased or the vehicle purchased with the item installed.