Click to zoom in
The 2005-2011 Ford Crown Victoria Brake Stop Lamp Light Switch is a genuine OEM auto part that is designed to ensure the proper functioning of your vehicle's brake lights. This high-quality switch is an essential component of your vehicle's braking system, and is responsible for transmitting the signal from your brake pedal to the brake lights, indicating to other drivers when you are slowing down or stopping.
To install the 2005-2011 Ford Crown Victoria Brake Stop Lamp Light Switch Genuine New, follow the steps below:
-
Park your vehicle on a flat surface and turn off the engine.
-
Locate the old brake stop lamp light switch that needs to be replaced. It is typically located on the brake pedal arm near the top.
-
Use a socket set or wrench to carefully remove the nut that holds the old switch in place.
-
Carefully remove the old switch from the brake pedal arm.
-
Disconnect the wiring harness from the old switch.
-
Connect the wiring harness to the new switch.
-
Install the new switch onto the brake pedal arm, aligning it with the mounting hole.
-
Use the socket set or wrench to secure the new switch in place with the nut that was removed earlier.
-
Test the new switch by turning on the engine and verifying that the brake lights illuminate when the brake pedal is depressed.
The skill level required for this installation is low to moderate, and it should take approximately 15-30 minutes to complete. You will need a socket set or wrench to remove and install the switch. No special tools are required for this installation.
Important: Be sure to follow all safety precautions and manufacturer instructions carefully to avoid injury or damage to your vehicle. Also, make sure the new switch is securely attached and operates properly for proper brake light function.
Read More
EASY NO HASSLE RETURN INFORMATION
Simply return your part in the exact same condition and packaging that you received it in within 30 days for a full refund of the purchase price of the part, minus the original shipping charges. You don't even have to contact us. Just be sure the read the requirements below and follow the instructions at the bottom of this page.
WHAT CAN NOT BE RETURNED:
Any part that does not have all of the original packaging with the attached manufacturer part number label.
Believe it or not, this is super important! Don't throw away the packaging. Manufacturers won't accept returns on a part without the genuine OEM Packaging, so we won't be able to credit you. (Even if the part is brand new with no packaging, we would have to return it to you).
WE ALSO CANNOT ACCEPT YOUR RETURN IF:
You have installed or attempted to install or disassemble the part
You have painted the part.
You have broken the part.
You have lost the original packaging.
You have gotten the part wet, or the part has greasy fingerprints.
ELECTRICAL PARTS.
Electrical parts can only be returned if they have not been installed, programmed, or plugged in. If the part shows signs, of an attempted install we will be unable to accept your return.
An electrical part is any part that plugs in, contains a switch, sensor, circuit board, or electrical wiring.
All Products are. covered by a 1-year Warranty.
Our Warranty Coverage
We will replace the parts free of charge for any reason not caused by collision or installation, other human intervention, incorrect application, modifications, use of the products outside the context of its normal, customary, and intended operating conditions (including without limitation, any form of commercial, fleet, rental or off-road use), or physical damage for 1 year and only for the vehicle in which the part was originally installed.
One Time replacement.
Warranty Covers only one replacement in the warranty period. Multiple Replacements are not covered, after one replacement warranty will no longer be in effect.
Warranty Is nontransferable and is only valid for the VIN number of the vehicle for which it was purchased. Warranty does not transfer to the new owner of the item purchased or the vehicle purchased with the item installed.