Click to zoom in
Passenger Side
This is a new rear bumper step pad for the 2005-2009 Ford F-150. It is a Genuine OEM (Original Equipment Manufacturer) part, meaning it is manufactured by Ford specifically for these vehicle models.
The rear bumper step pad is an important component of the vehicle's exterior, as it provides a non-slip surface for passengers to step on when entering or exiting the truck bed. Over time, the step pad can become worn or damaged, causing it to become slippery and potentially dangerous.
Installation Instructions:
Installing a new genuine Ford rear bumper step pad on a 2005-2009 Ford F-150 can be done with just a few basic tools. Here are the steps to follow:
Tools Needed:
- Socket wrench set
- Flat-head screwdriver
- Torx driver set
Skill Level:
- Moderate
Estimated Time:
- 30-60 minutes
-
Start by removing the old step pad from the rear bumper. This may involve removing screws or bolts that hold it in place. Use a socket wrench set to loosen and remove these fasteners.
-
Once the old step pad is removed, clean the surface of the bumper where the new step pad will be installed. Use a flat-head screwdriver to remove any old adhesive or debris.
-
Take the new genuine Ford rear bumper step pad and place it onto the bumper, making sure it is properly aligned. Use a Torx driver set to tighten the screws or bolts that secure it to the bumper.
-
Once the new step pad is securely attached, check it for proper fit and alignment. Make any necessary adjustments.
-
Finally, step back and admire your new genuine Ford rear bumper step pad!
Note: It is recommended to consult your vehicle's owner's manual for specific instructions and safety precautions before attempting this installation.
Read More
EASY NO HASSLE RETURN INFORMATION
Simply return your part in the exact same condition and packaging that you received it in within 30 days for a full refund of the purchase price of the part, minus the original shipping charges. You don't even have to contact us. Just be sure the read the requirements below and follow the instructions at the bottom of this page.
WHAT CAN NOT BE RETURNED:
Any part that does not have all of the original packaging with the attached manufacturer part number label.
Believe it or not, this is super important! Don't throw away the packaging. Manufacturers won't accept returns on a part without the genuine OEM Packaging, so we won't be able to credit you. (Even if the part is brand new with no packaging, we would have to return it to you).
WE ALSO CANNOT ACCEPT YOUR RETURN IF:
You have installed or attempted to install or disassemble the part
You have painted the part.
You have broken the part.
You have lost the original packaging.
You have gotten the part wet, or the part has greasy fingerprints.
ELECTRICAL PARTS.
Electrical parts can only be returned if they have not been installed, programmed, or plugged in. If the part shows signs, of an attempted install we will be unable to accept your return.
An electrical part is any part that plugs in, contains a switch, sensor, circuit board, or electrical wiring.
All Products are. covered by a 1-year Warranty.
Our Warranty Coverage
We will replace the parts free of charge for any reason not caused by collision or installation, other human intervention, incorrect application, modifications, use of the products outside the context of its normal, customary, and intended operating conditions (including without limitation, any form of commercial, fleet, rental or off-road use), or physical damage for 1 year and only for the vehicle in which the part was originally installed.
One Time replacement.
Warranty Covers only one replacement in the warranty period. Multiple Replacements are not covered, after one replacement warranty will no longer be in effect.
Warranty Is nontransferable and is only valid for the VIN number of the vehicle for which it was purchased. Warranty does not transfer to the new owner of the item purchased or the vehicle purchased with the item installed.