2019-2023 Mazda 3 Washer Fluid Level Sensor OEM New

This Genuine OEM Washer Fluid Level Sensor is designed to fit 2019-2023 Mazda 3 models, providing a new sensor to monitor the level of washer fluid in your vehicle's reservoir. Crafted to OEM specifications, this sensor ensures that you are alerted when the washer fluid level is low, allowing you to maintain clear visibility by refilling the reservoir as needed. It is not an aftermarket replacement, providing you with the same quality as the sensor sold at the Mazda dealership.

Installation Instructions:

1. Before starting the installation, make sure your Mazda 3 is safely parked and the engine is turned off.
2. Locate the washer fluid reservoir in your vehicle.
3. Carefully disconnect the old washer fluid level sensor from its electrical connector.
4. Remove the old sensor from the reservoir by gently pulling it out.
5. Inspect the new Genuine OEM washer fluid level sensor to ensure it is free from defects.
6. Insert the new sensor into the washer fluid reservoir, ensuring it is properly seated.
7. Reconnect the sensor to its electrical connector.
8. Turn on your vehicle's ignition to check if the sensor is functioning correctly. The low washer fluid warning light should illuminate when the fluid level is low.
9. Double-check the placement and fit of the new washer fluid level sensor to ensure it operates as intended.
10. The entire installation process typically takes around 15-30 minutes and is considered a simple skill-level job.

Vehicle Fitment:

This washer fluid level sensor is designed to be compatible with the following Mazda 3 models:

• 2019-2023 Mazda 3